The most common problem with any new PC build is partially made or improper connections. Most of the troubleshooting procedures in this blog require that the cover be removed form the PC and that some components be removed or reconnected. For this reason, it's best to plug in the PC through a switched power strip, so you can use the power strip switch to isolate the system from the electrical supply before every repair attempt.
Most people, even professional technicians, tend to get a little sloppy when troubleshooting, often accidentally introducing a new problem to replace the old. The main key to any type of troubleshooting is to go one step at a time. That way, when the original problem is corrected, you'll know exactly what did the trick, and if you create a new problem, you'll know what went wrong.
We will address five basic scenarios in this blog, ranging from a stone dead system to a lack of functionality, such as a modem that won't connect. Although these procedures will uncover most assembly errors, there is often no way to isolate a dead component without having other known good parts to swap out. In the world of professional PC troubleshooting and repair, the "swap' till you drop" strategy is still the most common troubleshooting technique employed. Swapping components requires no expensive diagnostics software or hardware and is usually the quickest way to isolate a problem. Another reason to steer clear of specialized diagnostics tools is that they are geared to identifying problems with subcomponents that can't be fixed anyway. Finding out exactly which address is bad in the system RAM or in the cache memory of a drive or motherboard is of little use when you'll have to replace the whole assembly anyway.
These troubleshooting procedures are for a newly built PC. If you have been using the PC for some time for any new problem that arises you have to consider the possibility of a computer virus. One way to check whether you have a hardware problem or a virus problem at boot time is to boot from your original operating system CD. If you do contract a virus, there are many virus doctor programs you can buy with a reasonable certainty they will fix the problem, but you may need Internet access to download the latest virus inoculations form the manufacturer's Web site.
In general, if you computer a serious recurring software problem with your PC, and you has good backups of any important data, the most reliable fix is to wipe clean the hard drive by deleting the primary partition with the FDISK program and reinstall the software form scratch. Just be really sure you have the original CDs and serial numbers for all the software you use, in addition to good data backups, because once you FDISK, it's all gone. Before running FDISK, confirm that your operating system CD will boot!
Caution: We cannot reiterate enough times that you should disconnect power from the system before making any change inside the case; then reconnect after each change to check the result. If you smell a burnt electronics odor at any time, you have a blown component and should not attempt powering up again until it is found and replaced and the cause of the failure is determined.
